Elecrical Knowledge

What is electric energy:  The power to act by electricity is called electrical power or electric energy. Its unit is WAT (WH). Calculation of electrical energy can be done by the time of the work done from the electricity and the time for that work.                                 The largest unit of WH (WH) is KWH .1000 watt is equal to 1kwh. 1kwh is referred to as a unit and we use it in the same manner in practice. It is referred to as the board of trade unit and it is measured by the energy meter.                                  Now if we know the value of any instrument or how much power it uses, then we can also find it in its total usage unit through its medium. And if this is the focus of the unit charge, then we can find the bill for the month. Looking forward

The rule of ohms:                                     Found in three dimensions in any circuit Electric current Lightning v Electrical resistance                         Among the above dimensions, a specific relationship was identified by Ohm, which is called the rule of ohms, which is as follows. The rule of ohms:                                 According to Ohm's law, the flow of fluid in any closed circuit in constant heat is in proportional to the pressure of the pressure and in the perimeter of the blockage.                      So from this rule of us                                                       I get the formula I = V / R                     From this rule we can find all three dimensions

Magical Triangle for the Ohm Rule: loading...                                                                    In the above figure, the rule of ohms is clearly shown. According to the rule of the hypothesis, place thumbs on the parameter which you want to find from the three dimensions, and the remaining two dimensions will show you the result.                                         For example, put your thumb on the I ie I = V / R as a result resulted in putting thumb on the V with a thumb on V = IR and R, R = V / I result will be seen.

special resistance or residency.                                       It is also known as special resistance or residency.                                  In R = ρ L / A, if L = 1m, A = 1mxm is taken then R = ρ occurs, that is, the ideal barrier is the resistance obstructed by one meter of the concrete object.                   The unit of special resistance                                                  R = ρ L / A                                That is, ρ = RA / L                                                   ∴ ρ = ohms - mxm / m = ohms - meters                                                            Where m = m loading...

Horsepower and kilowatt:             Horsepower:                                     Horsepower is a unit of mechanical power, that means horsepower is used to measure power in mechanical engineering. Its definition is as follows.                                     Work is done by moving 75 kilograms of one meter in one second or moving 4500 kilograms a meter in one minute. It is called horsepower. loading...            Kilowatt:                              Kilowatt is a unit of electric power. Its definition is as follows.                                  Electricity rate is called electric power. Its unit is w and the larger unit is KWH                                                         1 HP = 735 watts = 0.735 kilowatt                                                And 1 kw = 1000 watts = 1.36 hp                                                                        In this way, know that Kilovot's unit is larger than hors

What is the ressistance ? What is the basis of its support?   ressistance:                        The characteristic of the conductor or substance to obstruct the flow of electricity from any object or carrier is called its barrier. It comes from the symbol R. and its unit is ohm. Ohm meter is used to measure it. The ohms meter is never connected to the supply; it is attached to the two ends of the ohmeter over the two ends of the instrument which is to measure the resistance.      Support of barrier:                         The resistance of the conductor is based on the following:          1. On the metal metal        2. On length of the carrier        3. On the thickness of the carrier        4. On the temperature of the carrier    1. On the metal of the vessel:                                       The carrier is made of the object. It is the basis of the carrier's resistance to the property's properties. The barrier of the carriers of different met

What is the conductivity?                                             The power of the conductor of the conductor or substance of the substance is called the conductivity or the conductivity of the conductor or substance. The contradiction is the opposite of the barrier, that is, the occupant's barrier is called its conductivity. The unit of resistance is ohms. When conductivity The unit ohm is read in reverse form. It is represented by the G symbol.               thus                                                 Conductivity = 1 / barrier                                                                                    It can be said

What is power or electric power?                                    The power rate from the power is called an electric power. It is represented by P symbol. Its unit is w (w). And it is measured by a wat meter.

That means obstacle or resistance                                                                  The characteristic of the conductor or substance to obstruct the flow of electricity from any object or carrier is called its barrier. It comes from the symbol R. and its unit is ohm. Ohm meter is used to measure it. The ohms meter is never connected to the supply; it is attached to the two ends of the ohmeter over the two ends of the instrument which is to measure the resistance.

What is electricity?                       The flow of electrons flowing into any conductor is called the current or electric current. Its symbol is I. and the ampere on the unit. It is measured by the ampere meter.

What is Potential Difference?                                                                                                                                     Potential difference can also be identified as the difference in the vibration. In either circuit, the processor or voltage that is required to perform a current between two points is called a potential difference. In other words, if the load is loaded, the voltage found on the battery or the generator's terminal PD is called. Its symbol is V. and its unit is volt. It is measured with voltmeter.                                           The formula showing the relationship between P.D. and Walt is as follows                                                                                 V = E -IR                                                                                       Where                                                                                              V = P.D.                  

What is electromotive force?                                                          The force that is responsible for carrying the current from any conductor or current from a conductor is called an electro-force force. In other words, the voltage recieved on the battery or the generator's terminal is called an electro-force force. Is,                                          Electromortive Force is shown with an E symbol and its unit is volt. And it is measured by voltmeter.

                          Many types of objects are found on earth. When a piece of any object is divided physically, the smallest part found in it is called atom and if the atom is chemically divided, then the smallest particle derived from it is called atomic (where the molecule and atom is atom Also referred to as)                       The structure of this molecule is composed of three types of particulates. Those called protons, electrons, and neutrons. These molecules are made of protons, electrons, and neutrons, in which proton has positive charge and electron negative charge whereas neutron Are neutral.                      There is a central nucleation in the center of the molecule, which contains protons and neutrons, while electrons live round circular rotation in a specific area around the molecule. Protein and electron are attracted to each other because of the positive and negative charge between them. Near Nucleus Electrical orbit of the electron in the orbit

Parellal circuit                         Hello guys today we will know about the parallel circuit, first welcome to our blog, this electrical Guruji, let us know what is the perarelal circuit Parallel Circuit:                        Suppose we have two types of load which we will call as Load 1 and Load 2, we will have two contacts, which we will learn from t 1 and t 2, same way, 2 will also get t 1 and t 2 Construct a contact with load 1 and load 2 of t1, and make a second contact by mixing the load 1 and t2 of load 2 in the same way. And then the two contacts are connected to the flow of the flow and the nautel, so in this way, the circuit that is ready is called Parallel Circuit. In this type of circuit the current is different when the voltage remains the same (per-load) Benefits of Parallel Circuits:                    Parallel circuits have advantages, all the loads from this type of circuit get the same voltage at the same time, so that all the loads cost the amper

DC                    Hello guys today we will know everyone about DC is familiar with DC but no society, but let's know today what is DC? What is DC?: The full name of DC is direct current due to its name, it is called a DC due to its name.                                    If the flow is not the same as the direction and value of its flowing, then that flow is called the DC flow. Uses of DC: We use DC in more evidence such as mobiel, mp3playar, and many such devices that are related to charging or have a battery, the hand clock is also run on dc. DC also has a huge contribution in chemical and safety devices.                                  In DC, there is + and - instead of phage and naturally.

Fleming's left hand rule           Hello friends today, our theme O Fleming's left hand rule is done in this rule generator. With this rule, we can know the direction of current generated in the generator, let us know in detail.                    According to the picture shown in the picture, the puzzle finger of his left hand, the other finger and the thumb kept at such a position, all three stayed at 90 °, then the thumb generator tells the direction of the disappearance of the armature. The puzzle gives the finger direction of the magnetic field, The finger will show the direction of the current generated in the generator                          This rule was discovered by a scientist named Fleming, so it is recognized by Fleming's left hand rule.

FLEMING RIGHT HANDS LOW                           Hello friends today our theme is the rule of right hand Fleming, this rule is useful for motor, so let us know about this rule in detail FLEMING LAFT HANDS LOW:                     According to this rule, the right finger of your right hand, the other finger and the thumb should be kept in such condition, in which each of the three is in a degree of 90 degrees, then the second finger indicates the direction of current flowing in the motor, and the direction of the magnetic field of the puzzle finger motor I would say that the thumb will tell the direction of the lost of the motor                      With this rule we can easily know the direction of the lost of the motor and in which direction the armature will be, and also the direction of its magnetic field.                      This rule was discovered by a scientist named Fleming, hence the rule was named after the scientist.