Ways to Improve Power Factor

By -

Ways to Improve Power Factor



ગુજરાતી માં માહિતી માટે અહીં ક્લિક કરો 
हिन्दी में जानकारी के लिए यहाँ क्लिक करे 


                Two ways are used to improve the power factor, as follows
By combining the
      1.capacitor into the parallel of the load
               This is one of the easiest and easiest ways to improve the power factor. The capacitor always takes the leading current. This eliminates leging currents and improves the power factor.
      2.Cicronas motor connection
           
               The power factor can be upgraded by running the cicronas motor in parallel with over-extension on the line which is to be upgraded in the power factor. Now this is very expensive in the motor cost, where it is used only when there is more advantage in comparison with its price Should be done

      3. Using a phase adwanser can also be improved in the power factor

Comments

Post a Comment

Popular posts from this blog

ERTHING

By -
Image
ERTHING                        Electricity is beneficial for us, but its loss is even more. Electricity can take our lives even if it does not go well. Now we can not get away from electricity because electricity has become part of our life. Light in the darkness, fan in the heat, so much of the electricity around us that we They even use it inadvertently. Along with this, the risk goes up. For this reason, we must definitely adopt a path of goodwill which can secure us and our own electricity so we must definitely do our work in our home to avoid all these. But first, do you know what the meaning is?  What is Erthing?            We have so many electric appliances in our house around us that sometimes we have been using it. Therefore the electrical equipment is in contact with our body, and therefore whenever there is a fault in the instrument then the body of the instrument comes in contact with us, so that the current passes through our body and we feel shock O
Read more

Distribution Transformer and Power Transformer

By -
Image
Distribution Transformer:                                     The transformer is used in the distribution of electrical energy. It is called Distribution Transformer. Its rating is 200 KVA and it is a step down type. In this transformer whether the load is loaded or not, it is functioning 24 hours a day. This means that iron lasts continuously throughout the day while copper is based on the load load. So much so that the load more loads of copper loses and loads less as copper Iron deficiency in such transformer should be lower than Copper Loss. In other words, the transformer's efficiency should be greater on the 50% load. Such transformer's voltage regulation should be good. Power Transformer:                                      The transformer that is used for the transmission of electrical energy is called a power transformer. The rating of this transformer is 200KVA. Power transformer can be used to step up or step down the voltage on both ends of the power l
Read more

D.C 3 POINT STARTER

By -
Image
                                 It can also be called a three point starter. Its structure is shown in Figure. To start the motor, the handle is moved from off position to the first contact position. The total obstacle is in the armature circuit, the field connection is connected directly to the supply through a volt coil. Comes in as soon as the speed of the motor increases in the same way as the archete back emf emits and decreases in the value of current Now the handle is moved to the second step. Again this type of function will be done eventually at the last step of the handle. This time the armature will connect directly to the supply and this time the handle does not come with a no-volt coil. The magnet will hold the handle in the walt coil, and the motor will not need to hold the handle to continue and the motor will rotate in full speed.                   Mechanism of 3 points Starter is done so that if the magnetism of the nvc coil is exhausted for any reason, and the
Read more